Skip to content

How the grade works

PeakHour works out the grade with fixed rules. The same measurements always give the same grade, whether or not Apple Intelligence is available. The AI only writes the explanation; it never sets the grade.

The grade counts five measurements:

  • Latency — the round trip from this Mac to the internet, over the whole path. The latency of each hop on the way is an estimate, and never reads 0.0 ms. See Router to ISP and ISP to Internet.
  • Jitter — how much the latency varies, on the worst hop of the path. Each hop is measured from this Mac, so a spike on your Wi-Fi counts in full.
  • Packet Loss — the share of data that doesn’t arrive.
  • Max Measured Speed — the download speed from the last speed test.
  • Responsiveness Under Load — round trips per minute (RPM) while the link is busy.

Each one lands in a band:

ExcellentGoodFairPoor
Latency< 30 ms30–60 ms60–100 ms≥ 100 ms
Jitter< 10 ms10–30 ms30–50 ms≥ 50 ms
Packet Loss< 0.5%—0.5–2%≥ 2%
Speed≥ 500 Mb/s50–500 Mb/s25–50 Mb/s< 25 Mb/s
Responsiveness≥ 1,000 RPM500–1,000 RPM200–500 RPM< 200 RPM

No packet loss at all shows as Perfect.

Speed and responsiveness come from the speed test. Until a test has run, the grade leaves responsiveness out and treats speed as Good.

One test can be low by chance, so the responsiveness in the grade is the median of up to your last 3 speed tests. They count only when they ran over the same connection and the same access point, with the same VPN state, within a few hours of each other: about 6.5 hours when tests run every 3 hours. The Advisor then says, for example, The grade uses the median of your last 3 Speed Tests. The Speed Test page and the log still show the value of each test.

When the upload is the slower side on Wi-Fi, and the measured upload is less than half of the upload of your plan, the Advisor places the slow responsiveness On this Mac’s Wi-Fi: the uploads wait on this Mac, because its Wi-Fi link sends more slowly than your plan. It then suggests that you move closer to the access point or connect to another one, and run the Speed Test over a cable at the router. It doesn’t suggest Smart Queue Management in this case, because the queue is not at the router.

The grade also watches for:

  • A weak Wi-Fi signal — −75 dBm or weaker.
  • A busy link — traffic above 90% of the speed that the last test measured, in either direction.
  • Monitors that do not answer — some of the sites or your ISP’s gateway stop answering while others still do.

When your ISP blocks traceroute, PeakHour can’t measure your ISP’s gateway, but the sites still answer. This doesn’t count as a monitor that does not answer: the Advisor shows the ISP link as Not measured, and the grade leaves it out.

GradeWhen
A+Every measurement is Excellent, and nothing else holds the grade back.
AEvery measurement is Good or better, and nothing else holds the grade back.
B+Every measurement is Good or better, with one concern such as a weak Wi-Fi signal or a busy link.
BA measurement is Fair, responsiveness under load is Poor, or some monitors do not answer.
CLatency, jitter, packet loss or speed is Poor, or there are two or more concerns at once.
DYour ISP’s gateway does not answer, or a Poor latency, jitter, packet loss or speed comes with two or more concerns.
FNo internet site answers.

The concerns are: a weak Wi-Fi signal, a busy link, monitors that do not answer, packet loss of 0.5% or more, latency over 100 ms, jitter over 50 ms, a download speed under 25 Mb/s, and responsiveness under load below 500 RPM.

A Poor responsiveness under load counts as Fair in the grade. It comes from the speed test, which fills your connection on purpose, so on its own it doesn’t mean your connection has a problem right now. The Your Network page still shows it as Poor, with the steps to fix it.

Every grade below an A has at least one reason under Issues identified on the Your Network page. An A or A+ has none.

A problem with a single site — for example one slow or unsteady service while the others are fine — does not lower your grade. It is a problem on the route to that site, not on your connection, and you can’t fix it from home. The Advisor lists it under Issues outside your network on The Internet page instead.

Was this page helpful?

Found something wrong, unclear, or out of date? Let us know and we'll fix it.